DEAR PRIORITY CUSTOMERS;

DUE TO SEVERAL CASES OF THE OUTER SHIFTING CABLE HOUSING BECOMING DAMAGED DURING GROUND TRANSPORTATION, WE HAVE CREATED THIS GUIDE TO AID IN REPLACING YOUR HOUSING.

THANK YOU FOR YOUR COOPERATION AND UNDERSTANDING. WE APPRECIATE YOUR SUPPORT OF PRIORITY BICYCLES.

STEP 1:
PLEASE DOUBLE CHECK THE SHIFTER IS IN THE POSITION OF 1ST GEAR.

FIND THE REAR GEAR CONTROL UNIT. PLEASE USE THE ALLEN WRENCH PROVIDED WITH YOUR BICYCLE AND UNSCREW THE BOLT IN THE BACK, WHERE THE ARROW IS POINTING.

STEP 2:
REMOVE THE CONTROL UNIT. PLEASE PAY ATTENTION TO THE SMALL PIN WHICH IS INSERTED INTO THE CENTER HUB. PLEASE KEEP IT WHERE IT IS.

STEP 3:
USE A SCREWDRIVER TO REMOVE THE SCREW AND COVER ON THE BACK OF THE CONTROL UNIT.

STEP 4:
USE A 10MM WRENCH TO LOOSEN THE BOLT HOLDING THE INNER CABLE. TAKE OUT THE INNER CABLE AND EXCHANGE THE DAMAGED OUTER CABLE WITH THE NEW CABLE WE SENT YOU.

STEP 5:
PLEASE FOLLOW THE ORIGINAL STEPS TO REASSEMBLE THE CONTROL UNIT BACK ONTO THE BICYCLE. PUSH THE CONTROL UNIT AS FAR ONTO THE WHEEL NUT AS YOU CAN BEFORE TIGHTENING.

STEP 6:
TO ENSURE THAT YOUR GEARS ARE ADJUSTED PROPERLY, SHIFT INTO GEAR 2 ON THE HANDLEBAR.  NEXT, ENSURE THAT THE INNER PADDLE YELLOW LINE APPEARS JUST PAST THE INNER LINE. IF IT LOOKS CORRECT, YOU'RE DONE! IF IT DOES NOT, PROCEED TO STEP 7.

STEP 7:
ADJUST THE INNER PADDLE YELLOW LINE AS APPROPRIATE USING THE ADJUSTER BARREL. FIRST, LOOSEN THE LOCKING NUT USING YOUR 10MM WRENCH, THEN TURN THE BARREL TO THE LEFT TO MOVE THE YELLOW LINE AWAY FROM THE HUB OR TURN THE BARREL TO THE RIGHT TO MOVE THE YELLOW LINE CLOSER TO THE HUB. TIGHTEN THE LOCKING NUT WHEN COMPLETE.

WE'RE SO SORRY FOR THIS INCONVENIENCE AND AGAIN APPRECIATE YOUR SUPPORT OF PRIORITY BICYCLES.

CONTACT PRIORITY BICYCLES AT (917) 819-1665 OR INFO@PRIORITYBICYCLES.COM IF YOU ANY HAVE FURTHER QUESTIONS.

THANK YOU!